EN UA
Hot Line: 8 800 200 05 65


Products

Tehnoelast

Tehnoelast

Application areas

Waterproofing of roofs, basements and other engineering structures.

Description of material

Technoelast is a waterproofing sheet produced by two-sided placing of a polymer-bitumen binder on a polyester or fiberglass base. The material withstands high temperature fluctuations, high mechanical loads, providing a long-term, reliable and effective waterproofing. Technoelast is a bioresistant material.

Technoelast K is designed to be used as the top layer of roof cladding. Coarse-grained dressing compound protects the material against sunlight.

Technoelast P is used for installation of the bottom layer of roof cladding and for waterproofing of engineering structures (basements, tunnels, etc.).

Technoelast can be used in all climatic zones (as determined in Construction Codes and Regulation (SNiP) 23-01-99*).

Method of application

The material is welded on a prepared surface using a gas burner. Material application: according to the Manual for Designing and Installation of Roofs Made of Polymer-Bitumen Materials Manufactured by the TechnoNICOL Corporation.

Storage

Store vertically, in a place protected from direct sunlight.

Service life — 25-30 years

Waterproofing warranty — 10 years



Types of material

    EPP

    HPP

    EKP

    TKP


Basic physical and mechanical properties

PropertyEPPHPPEKPTKP
Thickness, mm (0.1 mm)4,0 3,0 4,2 4,2
Mass of 1 m2, kg, (0.25 kg)4,95 3,9 5,2 5,2
Longitudinal/transverse breaking load, N, not less than polyester600/400 - 600/400 -
fiberglass- - - 800/900
fiberglass mat- 294/ - -
Bend point on R=25 mm and R=10 mm beam, C, no more than-25 -25 -25 -25
Heat endurance, , not less than100 100 100 100
Protective covering type on the topfilm without logo film without logo slate slate
on welded-on sidefilm with logo film with logo film with logo film with logo
Length / width, m101 101 101 101