Application areas
One-layer waterproofing of roof.
Description of material
Technoelast SOLO RP1 is a waterproofing sheet for one-layer roof cladding. Technoelast SOLO RP1 is thicker (min. 5 mm) and has a base made of special polyester. This type of base ensures the strength of the material combined with high dimensional stability, which is especially important for one-layer coverings.
Technoelast SOLO RP1 is produced with a coarse-grained dressing compound on the face and a non-woven sheet on the bottom side.
The edge of longitudinal overlapping (100–120 mm wide) is covered by a polymer film or a non-woven sheet. Wide range of colors. Enhanced fireproof performance according to Construction Codes and Regulation (SNiP) 21.01: flame spread group — RP1 (not spreading flame); inflammability group — V2 (moderately inflammable).
Method of application
The material is installed on a prepared base. The material can be installed mechanically, glued to mastic, welded on or placed using automatic equipment. Overlappings should be welded-on thoroughly to guarantee covering tightness. Material application: according to the Manual for Designing and Installation of Roofs with Mechanical Fastening Using Technoelast FIX and Technoelast SOLO Materials (mechanical fastening) and the Manual for Designing and Installation of Roofs Made of Polymer-Bitumen Materials Manufactured by the TechnoNICOL Corporation.
Storage
Store vertically, in a place protected from direct sunlight.
Speed and cost-efficiency of installation
Waterproofing warranty — 10 years
Service life — 25-30 years
Specifications:
Property | Technoelast SOLO RP1 | |
Thickness, mm (±0.1 mm) | 5,0 | |
Mass of 1 m2, kg, (±0.25 kg) | 6,4 | |
Breaking load when tensioning, N, not less than | polyester | 900/700 |
Bend point on R=25 mm and R=10 mm beam, °C, no more than | -25 | |
Heat endurance, °С, not less than | 100 | |
Fireproofing parameters | RP1 and V2 | |
Protective covering type | on the top | slate, basalt |
on the bottom | Non-woven sheet | |
Length / width, m | 8х1 |